- 您現在的位置：買賣IC網 > PDF目錄373928 > AD8013AR-14 (ANALOG DEVICES INC) RECTIFIER SCHOTTKY DUAL 30A 40V 275A-ifsm 0.55V-vf 1mA-ir TO-3P 30/TUBE PDF資料下載
參數資料
| 型號： | AD8013AR-14 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | RECTIFIER SCHOTTKY DUAL 30A 40V 275A-ifsm 0.55V-vf 1mA-ir TO-3P 30/TUBE |
| 中文描述： | 3 CHANNEL, VIDEO AMPLIFIER, PDSO14 |
| 封裝： | PLASTIC, SOIC-14 |
| 文件頁數： | 9/12頁 |
| 文件大?。?/td> | 319K |
| 代理商： | AD8013AR-14 |
–9–
REV. A
AD8013
FREQUENCY – Hz
1M
1G
10M
C
(
100M
–6
+1
0
–1
–2
–3
–4
–5
180
90
0
–90
P
G = –10
R
L
= 150
V
S
=
±
5V
V
S
= +5V
V
S
= +5V
V
S
=
±
5V
GAIN
PHASE
Figure 27. Closed-Loop Gain and Phase vs. Frequency,
G = –10, R
L
= 150
T o estimate the –3 dB bandwidth for closed-loop gains of 2 or
greater, for feedback resistors not listed in the following table,
the following single pole model for the AD8013 may be used:
ACL
.
G
1
+
SC
T
(
R
F
+
Gn rin
)
where:
C
T
= transcapacitance
>
1 pF
R
F
= feedback resistor
G
= ideal closed loop gain
1
+
R
F
R
G
rin
= inverting input resistance
>
150
ACL
= closed loop gain
T he –3 dB bandwidth is determined from this model as:
Gn
=
= noise gain
f
3
.
1
2
π
C
T
(
R
F
+
Gn rin
)
T his model will predict –3 dB bandwidth to within about 10%
to 15% of the correct value when the load is 150
and V
S
=
±
5 V. For lower supply voltages there will be a slight decrease in
bandwidth. T he model is not accurate enough to predict either
the phase behavior or the frequency response peaking of the
AD8013.
It should be noted that the bandwidth is affected by attenuation
due to the finite input resistance. Also, the open-loop output
resistance of about 12
reduces the bandwidth somewhat when
driving load resistors less than about 250
. (Bandwidths will
be about 10% greater for load resistances above a few hundred
ohms.)
T able I. –3 dB Bandwidth vs. Closed-Loop Gain and Feedback
Resistor, R
L
= 150
(SOIC)
V
S
– Volts
±
5
Gain
+1
+2
+10
–1
–10
+1
+2
+10
–1
–10
R
F
– Ohms
2000
845 (931)
301
698 (825)
499
2000
887 (931)
301
698 (825)
499
BW – MHz
230
150 (135)
80
140 (130)
85
180
120 (130)
75
130 (120)
80
+5
Driving Capacitive Loads
When used in combination with the appropriate feedback
resistor, the AD8013 will drive any load capacitance without
oscillation. T he general rule for current feedback amplifiers is
that the higher the load capacitance, the higher the feedback
resistor required for stable operation. Due to the high open-loop
transresistance and low inverting input current of the AD8013,
the use of a large feedback resistor does not result in large closed-
loop gain errors. Additionally, its high output short circuit current
makes possible rapid voltage slewing on large load capacitors.
For the best combination of wide bandwidth and clean pulse
response, a small output series resistor is also recommended.
T able II contains values of feedback and series resistors which
result in the best pulse responses. Figure 29 shows the AD8013
driving a 300 pF capacitor through a large voltage step with
virtually no overshoot. (In this case, the large and small signal
pulse responses are quite similar in appearance.)
General
T he AD8013 is a wide bandwidth, triple video amplifier that
offers a high level of performance on less than 4.0 mA per
amplifier of quiescent supply current. T he AD8013 uses a
proprietary enhancement of a conventional current feedback
architecture, and achieves bandwidth in excess of 200 MHz with
low differential gain and phase errors, making it an extremely
efficient video amplifier.
T he AD8013’s wide phase margin coupled with a high output
short circuit current make it an excellent choice when driving
any capacitive load. High open-loop gain and low inverting
input bias current enable it to be used with large values of
feedback resistor with very low closed-loop gain errors.
It is designed to offer outstanding functionality and performance
at closed-loop inverting or noninverting gains of one or greater.
Choice of Feedback & Gain Resistors
Because it is a current feedback amplifier, the closed-loop band-
width of the AD8013 may be customized using different values
of the feedback resistor. T able I shows typical bandwidths at
different supply voltages for some useful closed-loop gains when
driving a load of 150
.
T he choice of feedback resistor is not critical unless it is
important to maintain the widest, flattest frequency response.
T he resistors recommended in the table are those (chip
resistors) that will result in the widest 0.1 dB bandwidth without
peaking. In applications requiring the best control of bandwidth,
1% resistors are adequate. Package parasitics vary between the
14-pin plastic DIP and the 14-pin plastic SOIC, and may result
in a slight difference in the value of the feedback resistor used to
achieve the optimum dynamic performance. Resistor values and
widest bandwidth figures are shown in parenthesis for the SOIC
where they differ from those of the DIP. Wider bandwidths than
those in the table can be attained by reducing the magnitude of
the feedback resistor (at the expense of increased peaking),
while peaking can be reduced by increasing the magnitude of
the feedback resistor.
Increasing the feedback resistor is especially useful when driving
large capacitive loads as it will increase the phase margin of the
closed-loop circuit. (Refer to the section on driving capacitive
loads for more information.)
相關PDF資料 |
PDF描述 |
|---|---|
| AD8013AR-14-REEL | RECTIFIER SCHOTTKY DUAL 30A 45V 275A-ifsm 0.55V-vf 1mA-ir TO-3P 30/TUBE |
| AD8013ACHIPS | Single Supply, Low Power, Triple Video Amplifier |
| AD8013AN | Single Supply, Low Power, Triple Video Amplifier |
| AD8013AR-14-REEL7 | RECTIFIER SCHOTTKY DUAL 30A 50V 275A-ifsm 0.7V-vf 1mA-ir TO-3P 30/TUBE |
| AD8014ACHIPS | 400 MHz Low Power High Performance Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8013AR-14-EBZ | 功能描述:BOARD EVAL FOR AD8013AR-14 RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| AD8013AR-14-REEL | 制造商:Analog Devices 功能描述:OP Amp Triple Current Fdbk 制造商:Rochester Electronics LLC 功能描述:TRPL LO PWR VIDEO OP AMP - Tape and Reel |
| AD8013AR-14-REEL7 | 制造商:Analog Devices 功能描述:OP Amp Triple Current Fdbk ±6.5V/13V 14-Pin SOIC N T/R 制造商:Rochester Electronics LLC 功能描述:TRPL LO PWR VIDEO OP AMP - Tape and Reel |
| AD8013ARZ-14 | 功能描述:IC AMP VIDEO SGL SUPP LP 14-SOIC RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| AD8013ARZ-14-R7 | 功能描述:IC AMP VID SGL SUPP LP 14SOIC TR RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。