- 您現在的位置：買賣IC網 > PDF目錄10138 > AD7643BSTZRL (Analog Devices Inc)IC ADC 18BIT DIFFER W/REF 48LQFP PDF資料下載
參數資料
| 型號： | AD7643BSTZRL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 19/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 18BIT DIFFER W/REF 48LQFP |
| 標準包裝： | 2,000 |
| 系列： | PulSAR® |
| 位數： | 18 |
| 采樣率（每秒）： | 1.25M |
| 數據接口： | 串行，并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 80mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 48-LQFP |
| 供應商設備封裝： | 48-LQFP（7x7） |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個差分，雙極 |
| 配用： | EVAL-AD7643CBZ-ND - BOARD EVALUATION FOR AD7643 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD7643
Rev. 0 | Page 26 of 28
MICROPROCESSOR INTERFACING
The AD7643 is ideally suited for traditional dc measurement
applications supporting a microprocessor, and ac signal processing
applications interfacing to a digital signal processor. The
AD7643 is designed to interface with a parallel 8-bit or 16-bit
wide interface or with a general-purpose serial port or I/O ports
on a microcontroller. A variety of external buffers can be used
with the AD7643 to prevent digital noise from coupling into the
ADC. The SPI Interface (ADSP-219x) section illustrates the use
of the AD7643 with the ADSP-219x SPI-equipped DSP.
SPI Interface (ADSP-219x)
Figure 41 shows an interface diagram between the AD7643 and
an SPI-equipped DSP, the ADSP-219x. To accommodate the
slower speed of the DSP, the AD7643 acts as a slave device and
data must be read after conversion. This mode also allows the
daisy-chain feature. The convert command can be initiated in
response to an internal timer interrupt. The 18-bit output data
are read with three SPI byte access. The reading process can be
initiated in response to the end-of-conversion signal (BUSY
going low) using an interrupt line of the DSP. The serial
peripheral interface (SPI) on the ADSP-219x is configured for
master mode (MSTR) = 1, clock polarity bit (CPOL) = 0, clock
phase bit (CPHA) = 1, and the SPI interrupt enable (TIMOD) =
00 by writing to the SPI control register (SPICLTx). It should be
noted that to meet all timing requirements, the SPI clock should
be limited to 17 Mbps, allowing it to read an ADC result in less
than 1 μs. When a higher sampling rate is desired, it is
recommended to use one of the parallel interface modes.
BUSY
CS
SDOUT
SCLK
CNVST
AD7643
PFx
SPIxSEL (PFx)
MISOx
SCKx
PFx OR TFSx
ADSP-219x1
DVDD
MODE0
MODE1
EXT/INT
RD
INVSCLK
1ADDITIONAL PINS OMITTED FOR CLARITY.
06
02
4-
0
41
Figure 41. Interfacing the AD7643 to ADSP-219x
相關PDF資料 |
PDF描述 |
|---|---|
| MS3102R22-20S | CONN RCPT 9POS BOX MNT W/SCKT |
| MS27497E12A35SC | CONN RCPT 22POS WALL MNT W/SCKT |
| PX0931/10/P | CONN JAM NUT 10POS W/PINS |
| LTC2861IGN#TRPBF | IC TXRX RS485 20MBPS 16-SSOP |
| AD7679ACPZRL | IC ADC 18BIT SAR W/BUFF 48LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7645AQ | 制造商:AD 制造商全稱:Analog Devices 功能描述:12-Bit Buffered Miltiplying CMOS D/A Converter |
| AD7645BQ | 制造商:AD 制造商全稱:Analog Devices 功能描述:12-Bit Buffered Miltiplying CMOS D/A Converter |
| AD7645CQ | 制造商:AD 制造商全稱:Analog Devices 功能描述:12-Bit Buffered Miltiplying CMOS D/A Converter |
| AD7645GCQ | 制造商:AD 制造商全稱:Analog Devices 功能描述:12-Bit Buffered Miltiplying CMOS D/A Converter |
| AD7645GLN | 制造商:AD 制造商全稱:Analog Devices 功能描述:12-Bit Buffered Miltiplying CMOS D/A Converter |
發布緊急采購，3分鐘左右您將得到回復。