參數資料
型號: AD7490BRU-REEL
廠商: Analog Devices Inc
文件頁數: 4/29頁
文件大?。?/td> 0K
描述: IC ADC 12BIT 16CH 28-TSSOP T/R
產品變化通告: IDD Specification Change 17/Jun/2009
Product Discontinuance 27/Oct/2011
標準包裝: 2,500
位數: 12
采樣率(每秒): 1M
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 12.5mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 28-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 28-TSSOP
包裝: 帶卷 (TR)
輸入數目和類型: 16 個單端,單極
Data Sheet
AD7490
Rev. D | Page 11 of 28
Peak Harmonic or Spurious Noise
Peak harmonic or spurious noise is defined as the ratio of the
rms value of the next largest component in the ADC output
spectrum (up to fS/2 and excluding dc) to the rms value of the
fundamental. Normally, the value of this specification is
determined by the largest harmonic in the spectrum, but for
ADCs where the harmonics are buried in the noise floor, it is a
noise peak.
Intermodulation Distortion
With inputs consisting of sine waves at two frequencies, fa
and fb, any active device with nonlinearities creates distortion
products at the sum and difference frequencies of mfa ± nfb,
where m, n = 0, 1, 2, 3, and so on. Intermodulation distortion
terms are those for which neither m nor n are equal to zero.
For example, the second order terms include (fa + fb) and
(fa fb), while the third order terms include (2fa + fb), (2fa fb),
(fa + 2fb) and (fa 2fb).
The AD7490 is tested using the CCIF standard where two input
frequencies near the top end of the input bandwidth are used.
In this case, the second order terms are usually distanced in
frequency from the original sine waves, and the third order
terms are usually at a frequency close to the input frequencies.
As a result, the second and third order terms are specified
separately. The calculation of the intermodulation distortion is
per the THD specification, where it is the ratio of the rms sum
of the individual distortion products to the rms amplitude of
the sum of the fundamentals expressed in decibels.
相關PDF資料
PDF描述
AD7492ARZ-5 IC ADC 12BIT REF/CLOCK 24SOIC
AD7495BRM IC ADC 12BIT SRL LP W/REF 8MSOP
AD75004KP IC DAC 12BIT QUAD W/BUFF 28-PLCC
AD7521LN CONV D/A 12BIT 1MHZ 2LSB 18-DIP
AD7524LNZ IC DAC 8BIT MULTIPLYING 16DIP
相關代理商/技術參數
參數描述
AD7490BRU-REEL7 制造商:Analog Devices 功能描述:ADC Single SAR 1Msps 12-bit Serial 28-Pin TSSOP T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 1MSPS 12-BIT SERL 28TSSOP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:12 BIT 16 CHANNEL ADC IC - Tape and Reel
AD7490BRUZ 功能描述:IC ADC 12BIT 16CH 1MSPS 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率(每秒):1M 數據接口:串行,SPI? 轉換器數目:1 功率耗散(最大):- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤(4x4) 包裝:Digi-Reel® 輸入數目和類型:8 個單端,單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6
AD7490BRUZ-REEL 功能描述:IC ADC 12BIT 16CHAN 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7490BRUZ-REEL7 功能描述:IC ADC 12BIT 16CHAN 28TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7490SRU-EP-RL7 功能描述:模數轉換器 - ADC 12-BIT 16CH IC w/ Sequencer RoHS:否 制造商:Analog Devices 通道數量: 結構: 轉換速率: 分辨率: 輸入類型: 信噪比: 接口類型: 工作電源電壓: 最大工作溫度: 安裝風格: 封裝 / 箱體: