- 您現在的位置：買賣IC網 > PDF目錄10329 > AD7470ARUZ-REEL (Analog Devices Inc)IC ADC 10BIT PARLLEL 24TSSOP T/R PDF資料下載
參數資料
| 型號： | AD7470ARUZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/21頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 10BIT PARLLEL 24TSSOP T/R |
| 標準包裝： | 2,500 |
| 位數： | 10 |
| 采樣率（每秒）： | 1.75M |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 12mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 24-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，單極 |
REV. B
AD7470/AD7472
–12–
PARALLEL INTERFACE
The parallel interfaces of the AD7470 and AD7472 are 10 bits
and 12 bits wide, respectively. The output data buffers are acti-
vated when both
CS and RD are logic low. At this point, the con-
tents of the data register are placed onto the data bus. Figure 10
shows the timing diagram for the parallel port.
Figure 11 shows the timing diagram for the parallel port when
CS and RD are tied permanently low. In this setup, once BUSY
line goes from high to low, the conversion process is completed.
The data is available on the output bus slightly before the falling
edge of BUSY.
It is important to point out that data bus cannot change state
while the ADC is doing a conversion as this would have a detri-
mental effect on the conversion in progress. The data out lines
will go three-state again when either the
RD or the CS line goes
high. Thus the
CS can be tied low permanently, leaving the RD
line to control conversion result access. Refer to VDRIVE section
for output voltage levels.
t2
tCONVERT
t3
t4
t8
t5
t6
t7
t9
t10
BUSY
CS
RD
CONVST*
*
CONVST SHOULD GO HIGH WHEN THE CLK IS HIGH OR BEFORE THE FIRST CLK CYCLE.
Figure 10. Parallel Port Timing
t2
tCONVERT
t9
CONVST*
BUSY
DBx
DATA N
DATA N + 1
*
CONVST SHOULD GO HIGH WHEN THE CLK IS HIGH OR BEFORE THE FIRST CLK CYCLE.
Figure 11. Parallel Port Timing with
CS and RD Tied Low
t2
t3
t4
t8
t6
t7
CLK IN
CONVST
BUSY
CS
RD
DBX
tWAKEUP
t5
tCONVERT
Figure 12. Wake-Up Timing Diagram (Burst Clock)
相關PDF資料 |
PDF描述 |
|---|---|
| MS27473E22B35SLC | CONN HSG PLUG 100POS STRGHT SCKT |
| VI-B2V-IX-B1 | CONVERTER MOD DC/DC 5.8V 75W |
| CS5340-CZZR | IC ADC AUD 101DB 200KHZ 16-TSSOP |
| D38999/26FC8BN | CONN HSG PLUG 8POS STRGHT SCKT |
| D38999/20WH21BB | CONN HSG RCPT 21POS WALL MT SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7470ARUZ-REEL7 | 功能描述:IC ADC 10BIT PARLLEL 24TSSOP T/R RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7472 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:AD7470/AD7472: 1.75MSPS. 4mW 10-Bit/12-Bit SAR ADC Data Sheet (Rev. A. 3/00) |
| AD7472AR | 功能描述:IC ADC 12BIT PARALLEL 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| AD7472AR-REEL | 制造商:Analog Devices 功能描述:ADC Single SAR 1.5Msps 12-bit Parallel 24-Pin SOIC W T/R 制造商:Rochester Electronics LLC 功能描述:12 BIT 1.5MSPS PARALLEL ADC I.C. - Tape and Reel |
| AD7472AR-REEL7 | 功能描述:IC ADC 12BIT PARALLEL 24-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:12 采樣率（每秒）:300k 數據接口:并聯 轉換器數目:1 功率耗散（最大）:75mW 電壓電源:單電源 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC 包裝:帶卷 (TR) 輸入數目和類型:1 個單端，單極；1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。