AVCC = DV
參數資料
型號: AD7367BRUZ-5500RL7
廠商: Analog Devices Inc
文件頁數: 26/28頁
文件大小: 0K
描述: IC ADC 14BIT DUAL BIPO 24-TSSOP
設計資源: Driving the AD7366/7 Bipolar SAR ADC in Low-Distortion DC-Coupled Appls (CN0042)
標準包裝: 500
位數: 14
采樣率(每秒): 500k
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 2
功率耗散(最大): 88.8mW
電壓電源: 模擬和數字,雙 ±
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 24-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 24-TSSOP
包裝: 帶卷 (TR)
輸入數目和類型: 4 個單端,單極;4 個單端,雙極
AD7366-5/AD7367-5
Rev. A | Page 7 of 28
TIMING SPECIFICATIONS
AVCC = DVCC = 4.75 V to 5.25 V; VDD = 5 V to 16.5 V; VSS = 16.5 V to 5 V; VDRIVE = 2.7 V to 5.25 V; TA = TMIN to TMAX, unless otherwise noted.1
Table 4.
Parameter
2.7 V ≤ VDRIVE ≤ 5.25 V
Unit
Test Conditions/Comments
tCONVERT
Conversion time, internal clock. CONVST falling edge to BUSY falling edge.
1.25
μs max
For the AD7367-5.
1.25
μs max
For the AD7366-5.
fSCLK
10
kHz min
Frequency of serial read clock.
20
MHz max
tQUIET
50
ns min
Minimum quiet time required between the end of serial read and the start of the next
conversion.
t1
10
ns min
Minimum CONVST low pulse.
t2
40
ns min
CONVST falling edge to BUSY rising edge.
t3
0
ns min
BUSY falling edge to MSB valid once CS is low for t4 prior to BUSY going low.
t4
10
ns max
Delay from CS falling edge until Pin 1 (DOUTA) and Pin 23 (DOUTB) are three-state disabled.
20
ns max
Data access time after SCLK falling edge.
t6
7
ns min
SCLK to data valid hold time.
t7
0.3 × tSCLK
ns min
SCLK low pulse width.
t8
0.3 × tSCLK
ns min
SCLK high pulse width.
t9
10
ns max
CS rising edge to DOUTA, DOUTB, high impedance.
tPOWER-UP
70
μs max
Power up time from shutdown mode; time required between CONVST rising edge and
CONVST falling edge.
1 Sample tested during initial release to ensure compliance. All input signals are specified with tR = tF = 5 ns (10% to 90% of VDRIVE) and timed from a voltage level of 1.6 V.
All timing specifications given are with a 25 pF load capacitance. With a load capacitance greater than this value, a digital buffer or latch must be used. See the
Terminology section and Figure 25.
2 The time required for the output to cross is 0.4 V or 2.4 V.
相關PDF資料
PDF描述
MAX9757ETJ+T IC AMP AUDIO PWR 2.3W AB 32TQFN
D38999/26WJ7AN CONN HSG PLUG 99POS STRGHT PINS
LTC1288IS8#TR IC ADC 12BIT 3V SAMPLING 8SOIC
MAX9756ETX+T IC AMP AUDIO PWR 2.3W AB 36TQFN
MAX9754ETI+T IC AMP AUDIO PWR 2.2W D 28TQFN
相關代理商/技術參數
參數描述
AD7367BRUZ-5-RL7 功能描述:IC ADC 14BIT DUAL BIPO 24-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD7367BRUZ-REEL7 制造商:AD 制造商全稱:Analog Devices 功能描述:1 MSPS, 8-Channel, Software-Selectable, True Bipolar Input, 12-Bit Plus Sign ADC
AD7367BRUZ-RL7 功能描述:IC ADC 14BIT SAR 1MSPS 24TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1,000 系列:- 位數:16 采樣率(每秒):45k 數據接口:串行 轉換器數目:2 功率耗散(最大):315mW 電壓電源:模擬和數字 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) 輸入數目和類型:2 個單端,單極
AD736AK 制造商:Analog Devices 功能描述:
AD736AQ 功能描述:IC TRUE RMS/DC CONV LP 8-CDIP RoHS:否 類別:集成電路 (IC) >> PMIC - RMS 至 DC 轉換器 系列:- 標準包裝:46 系列:- 電流 - 電源:1.2mA 電源電壓:±18 V,36 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC(0.295",7.50mm 寬) 供應商設備封裝:16-SOIC W 包裝:管件