low impedance sources" />
參數資料
型號: AD5424YRUZ
廠商: Analog Devices Inc
文件頁數: 17/29頁
文件大?。?/td> 0K
描述: IC DAC 8BIT MULTIPLYING 16-TSSOP
產品培訓模塊: Data Converter Fundamentals
DAC Architectures
標準包裝: 96
設置時間: 30ns
位數: 8
數據接口: 并聯
轉換器數目: 1
電壓電源: 單電源
功率耗散(最大): 25µW
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 16-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 16-TSSOP
包裝: 管件
輸出數目和類型: 2 電流,單極;2 電流,雙極
采樣率(每秒): 20.4M
產品目錄頁面: 782 (CN2011-ZH PDF)
配用: EVAL-AD5424EBZ-ND - BOARD EVALUATION FOR AD5424
Data Sheet
AD5424/AD5433/AD5445
Rev. D | Page 23 of 28
Provided the DAC switches are driven from true wideband
low impedance sources (VIN and AGND), they settle quickly.
Consequently, the slew rate and settling time of a voltage
switching DAC circuit is determined largely by the output op
amp. To obtain minimum settling time in this configuration, it
is important to minimize capacitance at the VREF node (voltage
output node in this application) of the DAC. This is done by using
low inputs capacitance buffer amplifiers and careful board design.
Most single-supply circuits include ground as part of the analog
signal range, which in turns requires an amplifier that can handle
rail-to-rail signals. There is a large range of single-supply
amplifiers available from Analog Devices.
PARALLEL INTERFACE
Data is loaded to the AD5424/AD5433/AD5445 in the format
of an 8-, 10-, or 12-bit parallel word. Control lines CS and R/W
allow data to be written to or read from the DAC register. A
write event takes place when CS and R/W are brought low, data
available on the data lines fills the shift register, and the rising
edge of CS latches the data and transfers the latched data-word
to the DAC register. The DAC latches are not transparent, thus
a write sequence must consist of a falling and rising edge on CS
to ensure that data is loaded to the DAC register and its analog
equivalent is reflected on the DAC output.
A read event takes place when R/W is held high and CS is
brought low. New data is loaded from the DAC register back to
the input register and out onto the data line where it can be read
back to the controller for verification or diagnostic purposes.
MICROPROCESSOR INTERFACING
ADSP-21xx-to-AD5424/AD5433/AD5445 Interface
the ADSP-21xx series of DSPs as a memory-mapped device. A
single wait state may be necessary to interface the AD5424/
AD5433/AD5445 to the ADSP-21xx, depending on the clock
speed of the DSP. The wait state can be programmed via the
data memory wait state control register of the ADSP-21xx
(see the ADSP-21xx family user’s manual for details).
03160-056
R/W
DB0 TO DB11
AD5424/
AD5433/
AD5445*
ADDRESS
DECODER
CS
DATA 0 TO
DATA 23
ADDRESS BUS
ADDR0 TO
ADRR13
ADSP-21xx*
DATA BUS
DMS
WR
*ADDITIONAL PINS OMITTED FOR CLARITY
Figure 56. ADSP21xx-to-AD5424/AD5433/AD5445 Interface
Figure 57 shows the interface between the AD5424/AD5433/
AD5445 and the 8xC51 family of DSPs. To facilitate external
data memory access, the address latch enable (ALE) mode is
enabled. The low byte of the address is latched with this output
pulse during access to external memory. AD0 to AD7 are the
multiplexed low order addresses and data bus and require
strong internal pull-ups when emitting 1s. During access to
external memory, A8 to A15 are the high order address bytes.
Since these ports are open drained, they also require strong
internal pull-ups when emitting 1s.
03160-063
R/W
DB0 TO DB11
AD5424/
AD5433/
AD5445*
ADDRESS
DECODER
CS
AD0 TO AD7
ADDRESS BUS
A8 TO A15
8051*
DATA BUS
WR
*ADDITIONAL PINS OMITTED FOR CLARITY
8-BIT
LATCH
ALE
Figure 57. 8xC51-to-AD5424/AD5433/AD5445 Interface
ADSP-BF5xx-to-AD5424/AD5433/AD5445 Interface
Figure 58 shows a typical interface between the AD5424/
AD5433/AD5445 and the ADSP-BF5xx family of DSPs. The
asynchronous memory write cycle of the processor drives the
digital inputs of the DAC. The AMSx line is actually four memory
select lines. Internal ADDR lines are decoded into AMS3-0, these
lines are then inserted as chip selects. The rest of the interface is
a standard handshaking operation.
03160-057
R/W
DB0 TO DB11
AD5424/
AD5433/
AD5445*
ADDRESS
DECODER
CS
DATA 0 TO
DATA 23
ADDRESS BUS
ADDR1 TO
ADRR19
ADSP-BF5xx
DATA BUS
AMSx
AWE
*ADDITIONAL PINS OMITTED FOR CLARITY
Figure 58. ADSP-BF5xx-to-AD5424/AD5433/AD5445 Interface
相關PDF資料
PDF描述
IDT23S08E-1HPGI IC CLK MULT PLL HI DRV 16-TSSOP
IDT23S08E-1HPGGI IC CLK MULT ZD HI DRIVE 16-TSSOP
VI-J5V-MZ-F3 CONVERTER MOD DC/DC 5.8V 25W
IDT23S08E-5HDCI IC CLK MULT PLL HI DRV 16-SOIC
VI-J5V-MZ-F1 CONVERTER MOD DC/DC 5.8V 25W
相關代理商/技術參數
參數描述
AD5424YRUZ 制造商:Analog Devices 功能描述:8BIT DAC PARALLEL I/F SMD 5424
AD5424YRUZ-REEL 功能描述:IC DAC 8BIT MULTIPLYING 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP,MICROWIRE?,QSPI?,串行,SPI? 轉換器數目:1 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型,TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):2.7M
AD5424YRUZ-REEL7 功能描述:IC DAC 8BIT MULTIPLYING 16-TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 設計資源:Unipolar, Precision DC Digital-to-Analog Conversion using AD5450/1/2/3 8-14-Bit DACs (CN0052) Precision, Bipolar, Configuration for AD5450/1/2/3 8-14bit Multiplying DACs (CN0053) AC Signal Processing Using AD5450/1/2/3 Current Output DACs (CN0054) Programmable Gain Element Using AD5450/1/2/3 Current Output DAC Family (CN0055) Single Supply Low Noise LED Current Source Driver Using a Current Output DAC in the Reverse Mode (CN0139) 標準包裝:10,000 系列:- 設置時間:- 位數:12 數據接口:DSP,MICROWIRE?,QSPI?,串行,SPI? 轉換器數目:1 電壓電源:單電源 功率耗散(最大):- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-8 薄型,TSOT-23-8 供應商設備封裝:TSOT-23-8 包裝:帶卷 (TR) 輸出數目和類型:1 電流,單極;1 電流,雙極 采樣率(每秒):2.7M
AD5425 制造商:AD 制造商全稱:Analog Devices 功能描述:8-Bit, High Bandwidth Multiplying DAC with Serial Interface
AD5425BRM 制造商:Analog Devices 功能描述:DAC 1CH R-2R 8BIT 10PIN USOIC - Bulk