- 您現在的位置：買賣IC網 > PDF目錄2027 > 8375 (3M)SHEETS HARD LAM DISSP WHT 5X12' PDF資料下載
參數資料
| 型號： | 8375 |
| 廠商： | 3M |
| 文件頁數： | 3/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | SHEETS HARD LAM DISSP WHT 5X12' |
| MSDS 材料安全數據表： | 8300 Series Hard Laminate MSDS |
| 標準包裝： | 5 |
| 系列： | 8300 |
| 墊子類型： | 桌子，工作臺卷筒 |
| 形狀： | 矩形 |
| 長度： | 12'（3.66m） |
| 寬： | 5'（1.52m） |
| 厚度： | 0.04"（1.02mm） |
| 顏色： | 白 |
| 材質： | Laminate |
| 特點： | 耗散 |
| 其它名稱： | 05400718636 98079816025 |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
11
78-8136-3801-8
14.0 Use of Doublesided Tape
Rather than install staticdissipative laminate to benchtops with adhesives in the traditional manner, some
customers attempt to adhere the laminate with doublecoated tape (i.e., tape with adhesive on both sides). Those
customers should be made aware that there are several shortcomings associated with this procedure.
A.
Internal stresses within the laminate unique to the manufacturing process as well as variations in the
moisture content of the ambient air can prevent the laminate sheets from laying flat. The adhesives
typically used to install laminate (described in Section 11.0) are strong enough to overcome these
stresses, but doublesided tape is generally not.
B.
On a laminate benchtop, the majority of the impact strength of the finished top is the result of the
uniform and intimate contact between the laminate and the substrate. Using doublesided tape offers
support for the laminate only at those spots where the tape is applied.
15.0 Recovering Installed Laminate
While most decorative commercial laminate can be recovered with additional laminate by sanding the existing
surface, cleaning it, and reapplying adhesive, this practice will not work well with 3M Static Dissipative Rigid
Worksurface 8300 Series. The 3M laminate is manufactured with a special, tough, abrasionresistant coating that
resists sanding. Therefore, adhesive will not bond well to the surface.
16.0 Cleaning and Maintenance
A.
The 3M rigid worksurface is readily cleaned with 3M Static Control Worksurface Mark Remover
8001. It can also be cleaned with warm water and mild detergents. Many commercially available
detergents are suitable, including common household dishwashing liquids.
B.
Nonabrasive, commercially available surface cleaners such as glass cleaners or products similar to
SoftScrub are suitable. Cleaners containing abrasives or strong acids or alkalines should be avoided.
C.
Stains such as those caused by solder flux, varnishes, ink, etc., can be removed with organic solvents
(alcohols, ketones, xylene, mineral spirits). Such stains can also be removed by a twominute exposure
to a 5% hypochlorite bleach (common laundry bleach) followed immediately by a clean water rinse.
D.
The surface should be protected from heat and from cuts and gouges by means of a hot pad and/or
cutting board. 3M Rigid Worksurfaces will not be affected by drops of molten solder, but will blister
if a soldering iron or some other intensely hot object is left on the surface. Blistering will occur at
approximately 400°F (204°C).
E.
ANYTIME THE LAMINATE SURFACE IS CLEANED OR OTHERWISE AFFECTED,
THE ELECTRICAL PERFORMANCE SHOULD BE VERIFIED.
17.0
Repair
A.
Colored paste can be used to visually repair minor defects in the top surface.
B.
Laminate that was adhered with contact adhesive and that lifts from the substrate can be readhered by
applying heat and pressure. A simple method is to place a piece of cloth over the problem area and then
iron it with a household iron.
相關PDF資料 |
PDF描述 |
|---|---|
| 8812 | TABLE MAT GREEN |
| 91070 | WRIST STRAP SPEIDEL 6'ANGLE 4MM |
| 91095 | CORD GROUND WS COILED 6' RT ANG |
| 9500 | FLOOR RUNNER ANTI-FATIGUE 3'X 5' |
| 960X/980X | WALL TRANSFORMER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 8375 5X12 | 功能描述:TABLE LAMINATE WHITE 5'X1' 制造商:scs 系列:- 零件狀態:有效 墊類型:桌子，工作臺 形狀:矩形 長度:5'（1.52m） 寬度:1'（0.30m） 厚度:0.039"（0.99mm） 顏色:白 材料:層壓 特性:- 包括:- 標準包裝:5 |
| 83-750 | 功能描述:RF 連接器 STRT PLG 59/62/9209 8241 8279 UG-111/U RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型: |
| 83-750 (UG-111/U) | 制造商:Amphenol RF 功能描述:RF/COAXIAL UHF PLUG STRAIGHT SOLDER 制造商:Amphenol RF 功能描述:RF/COAXIAL, UHF PLUG, STRAIGHT, SOLDER 制造商:Amphenol RF 功能描述:RF/COAXIAL, UHF PLUG, STRAIGHT, SOLDER; Series:-; Connector Type:UHF Coaxial; Body Style:Straight Plug; Coaxial Termination:Solder; Coaxial Cable Types:RG59, RG62, RG140, RG210; Contact Material:Brass; Contact Plating:Silver ;RoHS Compliant: Yes |
| 8375-1032-A-0 | 制造商:RAF Electronic Hardware 功能描述: |
| 83751-3 | 制造商:TE CONNECTIVITY 功能描述:WRENCH-LOK 350-350, 500-4 TE ENERGY |
發布緊急采購，3分鐘左右您將得到回復。