- 您現在的位置：買賣IC網 > PDF目錄1887 > 73M2901CE-IGVR/F (Maxim Integrated Products)IC MODEM 3.3V V.22BIS 32-TQFP PDF資料下載
參數資料
| 型號： | 73M2901CE-IGVR/F |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 8/27頁 |
| 文件大小： | 0K |
| 描述： | IC MODEM 3.3V V.22BIS 32-TQFP |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,000 |
| 數據格式： | V.21，V.22，V.23，Bell 103，Bell 212A |
| 波特率： | 300 ~ 9.6k |
| 電源電壓： | 2.7 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-TQFP |
| 供應商設備封裝： | 32-TQFP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
73M2901CE Data Sheet
DS_2901CE_031
16
Rev. 3.4
6.4
Functional Considerations
6.4.1
SMS and V.23 Half Duplex
SMS (Short messaging Services) is the communications mode used to transmit text messages for cell
phones and eventually wire line phones as well (see the 73M2901CE SMS and Half Duplex V.23
Operation application note). The V.23 half duplex mode has been included with the addition of the B10
command (ATB10). The B10 command allows the used to turn the transmitter on and off using the serial
interface
RTS signal. In this way the modems can easily communicate in half duplex mode using RTS to
enable transmission and
CTS to indicate the modem is ready to send data. The V.23 receiver response
time has also been improved to allow for fast line turnaround (reversal of the data flow). The pattern
generator has also been modified to send the proper alternating pattern used in the SMS handshake.
SMS messaging is very similar to the format used for Caller ID, so the 2901CE can also be used to send
Caller ID messages to equipment designed to use and display Caller ID information. A typical command
line for a dial up connection would be: ATY0B10S73-32C2R2S10=255<CR>. These commands are
broken out as follows:
Y0
Clear channel mode (1200 bps)
B10
V.23 HDX gated by
RTS
S73-32
No 125mS wait between commands
C2
DCD follows the raw received carrier
R2
Toggle
DTR to hang up
S10=255
Disable loss of carrier timeout
Note that
RTS/CTS flow control cannot be used when using V.23 half duplex since RTS is used to turn
the carrier on and off. XON/XOFF flow control should be used instead if flow control is needed. The
transmitter
RTS to carrier on delay time is 10mS and the off delay is 5mS.
6.4.2
Leased Line Mode
One of the drawbacks to the earlier 73M2901 modems is that they are designed primarily for dial-up
modem applications. This made it difficult to use them in some non-dial-up designs. The 73M2901CE
adds a leased line mode that allows a modem to go into the data mode without having to go through a
normal handshake or the need for a connection to another modem. The leased line mode is enabled
using the @L1 command in the initialization string. The 73M2901CE leased line mode should not be
thought of as limited to only leased line. It is also suited to radio links and any applications where the
modem needs to be ready to go when it is first connected. Leased line mode can be used with all
modulation modes that are supported by the 73M2901CE. Table 1 shows typical command initialization
strings that can be used.
Table 2: Leased Line Initialization Commands
V22bis LL
ATFS99=1Y6K3C1R2S30=4S70=12S26+4O2@L1
V22 LL
ATFS99=1Y6K3C1R2S30=8@L1
B212 LL
ATFS99=1Y6K3C1R2S30=16@L1
B103 LL
ATFS99=1Y6K3C1R2S30=32@L1
B202 RX LL
ATFS99=1Y6K3C1R2B4@L1
B202 TX LL
ATFS99=1Y6K3C1R2B5@L1
V23 HDX LL
ATFS99=1Y0C2R2B10@L1
V23 TX1200 LL
ATFS99=1Y6K3C1R2B3@L1
V23 TX75 LL
ATFS99=1Y6K3C1R2B2@L1
V21 LL
ATFS99=1Y6K3C1R2S30=64@L1
相關PDF資料 |
PDF描述 |
|---|---|
| 73S1209F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
| 73S1210F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
| 73S1215F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
| 73S1217F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
| 73S1217F-68MR/F/PE | IC SOC SMART CARD READER 68QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 73M2901CE-IM/F | 功能描述:電信線路管理 IC V.22bis Single-Chip Modem RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M2901CE-IM/F1 | 功能描述:電信線路管理 IC RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M2901CE-IMR/F | 功能描述:電信線路管理 IC V.22bis Single-Chip Modem RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M2901CE-IMR/F1 | 功能描述:電信線路管理 IC RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M2901CL | 制造商:TDK 制造商全稱:TDK Electronics 功能描述:V.22 BIS SINGLE CHIP MODEM |
發布緊急采購，3分鐘左右您將得到回復。