![](http://datasheet.mmic.net.cn/30000/6564_datasheet_1834841/6564_2.png)
All dimensions are in inches. Tolerances (except noted): .xx = ±.02” (,51 mm), .xxx = ± .005” (,127 mm).
All specifications are to the latest revisions. Specifications are subject to change without notice.
Registered trademarks are the property of their respective companies. Made in USA
7/10/02 SY/EH/LS
PomonaACCESS 90747 (800) 444-6785 or (425) 446-6010
Last saved by Laura Goldberg
More drawings available at www.pomonaelectronics.com
C:\Laura Goldberg\FlukeDataSheet \d6380_6562-63-64_2_02.doc
Page 2 of 2
Model 6380, 6562, 6563, 6564
Female Mini-Connector
“Do-It-Yourself”
Sales: 800-490-2361 Fax: 888-403-3360
Technical Assistance: 800-241-2060
ASSEMBLY INSTRUCTIONS
1.
Using a flat tip screwdriver, remove lid from connector.
2.
Cut back extension wire jacket (if applicable) 5/8”, strip back individual wires ”.
3.
Remove the elastomer strain relief from the connector. Insert wires into the strain relief until flush with the extension
wire outer jacket (5/8”).
4.
Loosen the two wire terminal screws (Approximately 3 turns counter clockwise) using a small flat tip
screwdriver.
5.
Insert the stripped Red* wire under the (-) terminal screw, and the remaining wire under the (+) terminal screw.
Tighten down the two terminal screws.
6.
Install the lid and tighten down the lid screw.
*Color may vary outside of the USA.