
STANDARD
MICROCIRCUIT DRAWING
SIZE
A
5962-97610
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
REVISION LEVEL
SHEET
3
DSCC FORM 2234
APR 97
1.3 Absolute maximum ratings. 1/
Supply voltage range (V
CC
) 2/.........................................................
Signal voltage range (any pin except A9) 2/.....................................
Power dissipation (P
D
).....................................................................
Storage temperature range..............................................................
Lead temperature (soldering, 10 seconds).......................................
Data retention..................................................................................
Endurance (write/erase cycles)........................................................
RESET, OE, and A9 voltage for auto select and sector protect (V
ID
):
.......................................................................................................
-2.0 V dc to +7.0 V dc
-2.0 V dc to +7.0 V dc
0.33 W maximum at 5 MHz
-65
°
C to +150
°
C
+300
°
C
10 years minimum
10,000 cycles minimum
-2.0 V dc to +12.5 V dc 3/
1.4 Recommended operating conditions.
Supply voltage range (V
CC
)..............................................................
Input low voltage range (V
IL
)............................................................
Input high voltage range (V
IH
) ..........................................................
Case operating temperature range (T
C
)............................................
RESET, OE, and A9 voltage for auto select and sector protect (V
ID
):
.......................................................................................................
+4.5 V dc to +5.5 V dc
-0.5 V dc to +0.8 V dc
+2.0 V dc to V
CC
+ 0.5 V dc
-55
°
C to +125
°
C
+11.5 V dc to +12.5 V dc
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a
part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those listed
in the issue of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in
the solitation.
SPECIFICATION
DEPARTMENT OF DEFENSE
MIL-PRF-38534 - Hybrid Microcircuits, General Specification for.
STANDARDS
DEPARTMENT OF DEFENSE
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard for Microcircuit Case Outlines.
1/ Stresses above the absolute maximum ratings may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ Minimum DC voltage in input or I/O pins is –0.5 V dc. During voltage transitions, inputs may overshoot V
SS
to –2.0 V dc
for periods up to 20 ns. Maximum DC voltage on output and I/O pins V
CC
+0.5 V dc. During voltage transitions, outputs
may overshoot to V
CC
+2.0 V dc for periods up to 20 ns.
3/ Minimum DC input voltage on RESET, OE, and A9 is –0.5 V dc. During voltage transitions, RESET, OE, and A9 may
overshoot V
SS
to –2.0 V dc for periods up to 20 ns. Maximum DC input voltage on A9 is +13.5 V which may overshoot
to +14.0 V dc for periods up to 20 ns.