- 您現在的位置：買賣IC網 > PDF目錄97782 > 5962-9063301MCB (ANALOG DEVICES INC) QUAD OP-AMP, 2000 uV OFFSET-MAX, 4 MHz BAND WIDTH, CDIP14 PDF資料下載
參數資料
| 型號： | 5962-9063301MCB |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 運算放大器 |
| 英文描述： | QUAD OP-AMP, 2000 uV OFFSET-MAX, 4 MHz BAND WIDTH, CDIP14 |
| 封裝： | CERDIP-14 |
| 文件頁數： | 12/14頁 |
| 文件大小： | 459K |
| 代理商： | 5962-9063301MCB |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁
REV. C
AD713
–7–
MEASURING AD713 SETTLING TIME
The photos of Figures 2 and 3 show the dynamic response of
the AD713 while operating in the settling time test circuit of
Figure 1. The input of the settling time fixture is driven by a
flat-top pulse generator. The error signal output from the false
summing node of A1, the AD713 under test, is clamped, ampli-
fied by op amp A2 and then clamped again.
Figure 1. Settling Time Test Circuit
Figure 2. Settling Characteristics 0 V to +10 V Step.
Upper Trace: Output of AD713 Under Test (5 V/div).
Lower Trace: Amplified Error Voltage (0.01%/div)
The error signal is thus clamped twice: once to prevent overload-
ing amplifier A2 and then a second time to avoid overloading the
oscilloscope preamp. A Tektronix oscilloscope preamp type 7A26
was carefully chosen because it recovers from the approximately
0.4 V overload quickly enough to allow accurate measurement
of the AD713’s 1
s settling time. Amplifier A2 is a very high
speed FET input op amp; it provides a voltage gain of 10, am-
plifying the error signal output of the AD713 under test (providing
an overall gain of 5).
Figure 3. Settling Characteristics to –10 V Step.
Upper Trace: Output of AD713 Under Test (5 V/div).
Lower Trace: Amplified Error Voltage (0.01%/ div)
POWER SUPPLY BYPASSING
The power supply connections to the AD713 must maintain a
low impedance to ground over a bandwidth of 4 MHz or more.
This is especially important when driving a significant resistive
or capacitive load, since all current delivered to the load comes
from the power supplies. Multiple high quality bypass capacitors
are recommended for each power supply line in any critical
application. A 0.1
F ceramic and a 1 F electrolytic capacitor
as shown in Figure 4 placed as close as possible to the amplifier
(with short lead lengths to power supply common) will assure
adequate high frequency bypassing in most applications. A
minimum bypass capacitance of 0.1
F should be used for any
application.
Figure 4. Recommended Power Supply Bypassing
相關PDF資料 |
PDF描述 |
|---|---|
| 5962-9063301MCB | QUAD OP-AMP, 2000 uV OFFSET-MAX, 4 MHz BAND WIDTH, CDIP14 |
| 5962-9080802Q2AX | DUAL OP-AMP, 6000 uV OFFSET-MAX, 1.3 MHz BAND WIDTH, CQCC20 |
| 5962-9080802QPAX | DUAL OP-AMP, 6000 uV OFFSET-MAX, 1.3 MHz BAND WIDTH, CDIP8 |
| 5962-9080901M2A | QUAD OP-AMP, 9000 uV OFFSET-MAX, 1.3 MHz BAND WIDTH, CQCC20 |
| 5962-9080901MCA | QUAD OP-AMP, 9000 uV OFFSET-MAX, 1.3 MHz BAND WIDTH, CDIP14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 5962-9063302MCA | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| 5962-9063501M2A | 制造商:Rochester Electronics LLC 功能描述:CMOS MULTIPLEXER - Bulk |
| 5962-9063501MVA | 制造商:Analog Devices 功能描述:Analog Multiplexer Single 8:1 18-Pin CDIP Tube 制造商:Analog Devices 功能描述:ANLG MUX SGL 8:1 16.5V/16.5V 18CDIP - Rail/Tube |
| 5962-9063502M2A | 制造商:Analog Devices 功能描述:ANLG MUX DUAL 4:1 16.5V/16.5V 20PIN LCC - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:CMOS MULTIPLEXER - Bulk |
| 59629063502MVA | 制造商:AD 功能描述:ADG529ATQ/883B |
發布緊急采購，3分鐘左右您將得到回復。