參數資料
型號： 40IMX7-24-8C2
元件分類： 電源模塊
英文描述： 1-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE
文件頁數： 3/18頁
文件大小： 299K
代理商： 40IMX7-24-8C2
Board Mountable
DC-DC Converters
IMX 7 Series
Edition 6/5.2000
11/18
R
Vo+
Vo–
+
U
ext
–
4 k
Uref 2.5 V
control
circuit
Vi+
Vi–
R
ext1
R
ext 2
06029
Fig. 18
Output voltage control for single output units by means of
the R-input
Double output units:
The R input (Trim) input is referenced to the primary side.
The figure below shows the circuit topology. Adjustment of
the output voltage is possible by means of either an exter-
nal resistor in the range of 100...105% of
Uo nom, or an ex-
ternal voltage source in the range of 75...105% of
Uo nom.
R (Trim)
Vo1+
Vo2–
+
U
ext
–
Vi+
Vi–
R
ext
Vo1–
Vo2+
06030
Control
circuit
Uref 2.5 V
Fig. 19
Output voltage control for double output units by means of
the R input
a) Adjustment by means of an external resistor.
Programming of the output voltage by means of an exter-
nal resistor
Rext1 is possible within a limited range of
100...105% of
Uo nom. Rext1 should be connected between
the R-pin and Vi–. Connection of
Rext1 to Vi+ may dam-
age the converter. The following table indicates suitable
resistor values for typical output voltages under nominal
conditions (
Ui nom, Io = 0.5 Io nom), with either paralleled
outputs or equal load conditions on each output.
b) Adjustment by means of an external voltage source
Uext.
For external output voltage programming in the range
75...105% of
Uo nom a (0...20 V) source Uext is required,
connected to the R-pin and Vi–. The table below indi-
cates typical
Uo versus Uext values under nominal condi-
tions (
Ui nom, Io = 0.5 Io nom), with either paralleled outputs
or equal load conditions on each output. Applying a con-
trol voltage greater than 20 V will set the converter into a
hiccup mode. Direct paralleling of the R-pins of units con-
nected in parallel is feasible.
Table 7: Uext for Uo = 75...105% Uo nom;
typical values (Ui nom, Io1, 2 = 0.5 Io1/2 nom)
Uo [% Uo nom]
Uext [V]
≥105
0
102
1.6
95
4.5
85
9
75
13
b) Adjustment by means of an external voltage
Uext be-
tween Vo– and R pins.
The control voltage range is 1.87...2.62 V and allows for
an adjustment in the range of approximately 75...105%.
(85...105% for 3.3 V outputs)
Uo 2.5 V
Uext ≈ –––––––––
Uo nom
Attempting to adjust the output below this range will
cause the converter to shutdown (hiccup mode).
Note: Applying an external control voltage >2.75 V may
damage the converter.
Table 6: Rext1 for Uo > Uo nom;
approximate values (Ui nom, Io1, 2 = 0.5 Io1/2 nom)
Uo [% Uo nom]
Rext [k]
105...108 (107 typically)
0
105
1.5
104
5.6
103
12
102
27
101
68
100
∞
相關PDF資料
PDF描述
48IWR1-1212-T 2-OUTPUT 1 W DC-DC REG PWR SUPPLY MODULE
48IML10-05-0L 1-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE
48IML10-0503-0M 2-OUTPUT 10 W DC-DC REG PWR SUPPLY MODULE
40IMX7-15-15-9XM 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE
40IMX15-03-8RG 1-OUTPUT 14.9 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
40IMX7-24-9C 功能描述:CONVERT DC/DC 24V 7W RoHS:否 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:5 系列:*
40IP120H 制造商:Siemens 功能描述:
40J100 功能描述:線繞電阻器 - 透孔 10watt 100ohm 5% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy
40J100E 功能描述:線繞電阻器 - 透孔 10watt 100ohm 5% Axial RoHS:否 制造商:Bourns 電阻:10 Ohms 容差:5 % 功率額定值:7 W 溫度系數:200 PPM / C 系列:FW 端接類型:Axial 工作溫度范圍:- 55 C to + 155 C 尺寸:9.5 mm Dia. x 26 mm L 封裝:Ammo 產品:Power Resistors Wirewound High Energy
40J1013 功能描述:LOCKWASHER INT 3/8 SS NONE RoHS:是 類別:開關 >> 配件 系列:- 標準包裝:100 系列:- 其它名稱:886.0007886.0007-ND
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*