- 您現在的位置：買賣IC網 > PDF目錄384084 > 1SMB3EZ8.2 (PanJit International Inc.) surface mount silicon Zener diodes PDF資料下載
參數資料
| 型號： | 1SMB3EZ8.2 |
| 廠商： | PanJit International Inc. |
| 元件分類： | 參考電壓二極管 |
| 英文描述： | surface mount silicon Zener diodes |
| 中文描述： | 硅表面貼裝齊納二極管 |
| 文件頁數： | 3/4頁 |
| 文件大?。?/td> | 313K |
| 代理商： | 1SMB3EZ8.2 |
PAGE . 3
REV.0-JUN.15.2005
1SMB3EZ6.8~1SMB3EZ100
APPLICATION NOTE:
Since the actual voltage available from a given zener diode is temperature dependent, it is necessary to determinejunction
temperature under any set of operating conditions in order to calculate its value. The following procedure is recommended:
Lead Temperature, T , should be determined from:
T = LA P + T
L is the lead-to-ambient thermal resistance ( C/W) and Pd is the power dissipation. The value for L will vary and depends
on the device mounting method.
L is generally 30-40 C/W for the various clips and tie points in common use and for printed
circuit board wiring.
The temperature of the lead can also be measured using a thermocouple placed on the lead as close as possible to the tie poin
The thermal mass connected to the tie point is normally large enough so that it will not significantly respond to heat surges
generated in the diode as a result of pulsed operation once steady-state conditions are achieved. Using the measured value of
TL, the junction temperature may be determined by:
T = T +
T
T
is the increase in junction temperature above the lead temperature and may be found from Figure 2 for a train of power puls
or from Figure 10 for dc power.
T
= J P
For worst-case design, using expected limits of I , limits of P and the extremes of T ( T ) may be estimated. Changes in volta
V , can then be found from:
V = V
T
V , the zener voltage temperature coefficient, is found from Figures 5 and 6.
Under high power-pulse operation, the zener voltage will vary with time and may also be affected significantly by the zener resis
For best regulation, keep current excursions as low as possible.
Data of Figure 2 should not be used to compute surge capa-bility. Surge limitations are given in Figure 3. They are lower than w
be expected by considering only junction temperature, as current crowding effects cause temperatures to be extremely high in s
spots resulting in device degradation should the limits of Figure 3 be exceeded.
D
A
A
A
A
J
L
JL
JL
Z
JL
L
D
Z
D
J
J
Z
Z
J
相關PDF資料 |
PDF描述 |
|---|---|
| 1SMB3EZ8.7 | surface mount silicon Zener diodes |
| 1SMB3EZ87 | surface mount silicon Zener diodes |
| 1SMB3EZ9.1 | surface mount silicon Zener diodes |
| 1SMB3EZ25 | surface mount silicon Zener diodes |
| 1SMB3EZ6.8 | surface mount silicon Zener diodes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 1SMB3EZ82-AU | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:GLASS PASSIVATED JUNCTION SILICON ZENER DIODES |
| 1SMB3EZ87 | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:SILICON ZENER DIODES |
| 1SMB3EZ87-AU | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:GLASS PASSIVATED JUNCTION SILICON ZENER DIODES |
| 1SMB3EZ9.1 | 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:SILICON ZENER DIODES |
| 1SMB3EZ9.1_R1_00001 | 制造商:PanJit Touch Screens 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。