- 您現在的位置：買賣IC網 > PDF目錄2021 > 19223 (Desco)MONITOR CONTINUOUS WORKSTATION PDF資料下載
參數資料
| 型號： | 19223 |
| 廠商： | Desco |
| 文件頁數： | 3/3頁 |
| 文件大小： | 0K |
| 描述： | MONITOR CONTINUOUS WORKSTATION |
| 標準包裝： | 1 |
| 類型： | 工作站監視器 |
| 使用： | 腕帶監視 |
| 特點： | 連續監視，NIST 可追溯，停放按扣，單芯系統 |
| 電源類型： | AC 適配器 |
| 包括： | AC 適配器，硬件，粘扣帶 |
The AC adapter must include the ground reference on the
barrel of the output plug.
The AC adapter therefore supplies the monitor with
ground.
This monitor simplifies the work area because no other
wiring is needed.
TO USE THE MONITOR:
1. Plug a wrist strap cord, not attached to the wristband,
into the monitored jack on the front of the unit. This will
activate the monitor, but will allow you 8 seconds before the
audible alarm circuit activates.
2. Snap the cord to the wristband and slip it on your wrist (it
should fit snugly). This should silence the audio and cause
the LEDs to switch from red to green. If this does not
happen, check the coil cord for continuity or damage.
Examine your wrist and ensure that it has a secure fit. If you
have dry skin, use antistatic hand lotion such as Desco’s
Reztore ESD Hand Lotion, Item No. 81080. When leaving
the area, a person can take the coil cord along or leave it
attached to the monitor. In either case, the audio alarm will
only sound for about eight seconds.
PARK SNAP
The audible alarm is designed to alert both operator and
supervisor. The Park Snap feature provides a means for an
operator to disconnect when normally leaving the work
area, without the audible alarm sounding, and it provides a
means of wrist cord storage (visual red LED will illuminate).
By the operator touching the Park Snap, the audible alarm
is disabled for about 8-10 seconds. The operator can
remove the wrist strap cord and attach socket and cord to
Park Snap for storage. Note: If cord is left plugged in to
monitor and not parked, unit will continuously alarm.
Specifications:
Operating Voltage
19222
120VAC, 50-60 Hz
19223
220VAC, 50-60 Hz
Response time to alarm
<50mS
Operating Temperature
0 - 40°C
Size
2.77"L x 2.07"W x .710"H
Note: Work surface must have a conductive layer such as
Dual Layer Rubber or Dissipative 3-Layer Vinyl or
Micastat Dissipative Laminate with conductive buried
layers. Desco Continuous Monitors are not recommended
for use with homogeneous matting.
TB-3024 Page 3 of 3
DESCO WEST - 3651 Walnut Avenue, Chino, CA 91710 (909) 627-8178 Fax (909) 627-7449
DESCO EAST - 90 Hudson Road, Canton, MA 02021-1407 (781) 821-8370 Fax (781) 575-0172 Web Site: Desco.com
Limited Warranty
Desco expressly warrants that for a period of one (1) year from
the date of purchase Desco Continuous Monitors will be free of
defects in material (parts) and workmanship (labor). Within the
warranty period, a credit for purchase of replacement Desco
Continuous Monitors, or, at Desco's option, the Continuous
Monitor will be repaired or replaced free of charge. If product
credit is issued, the amount will be calculated by multiplying the
unused portion of the expected one year life times the original unit
purchase price. Call Customer Service at 909-627-8178 (Chino,
CA) or 781-821-8370 (Canton, MA) for Return Material
Authorization (RMA) and proper shipping instructions and
address. Include a copy of your original packing slip, invoice, or
other proof of date of purchase. Any unit under warranty should
be shipped prepaid to the Desco factory. Warranty replacements
will take approximately two weeks.
If your unit is out of warranty, Desco will quote repair charges
necessary to bring your unit up to factory standards. Call
Customer Service at 909-627-8178 (Chino, CA) or 781-821-8370
(Canton, MA) for a Return Material Authorization (RMA) and
proper shipping instructions and address.
Warranty Exclusions
THE FOREGOING EXPRESS WARRANTY IS MADE IN LIEU OF
ALL OTHER PRODUCT WARRANTIES, EXPRESSED AND
IMPLIED, INCLUDING MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE WHICH ARE SPECIFICALLY
DISCLAIMED. The express warranty will not apply to defects or
damage due to accidents, neglect, misuse, alterations, operator
error, or failure to properly maintain, clean or repair products.
Limit of Liability
In no event will Desco or any seller be responsible or liable for
any injury, loss or damage, direct or consequential, arising out of
the use of or the inability to use the product. Before using, users
shall determine the suitability of the product for their intended use,
and users assume all risk and liability whatsoever in connection
therewith.
Maintenance and Calibration
The Multi-Mount Continuous Monitor is solid state and
designed to be maintenance free. The 19222/19223 is
calibrated to NIST traceable standards. There are no user
adjustments neccesary. Because of the wave distortion
sensing nature of the test circuit, special equipment is
required for calibration. We recommend that calibration be
performed using the Desco EMIT #50512 Continuous
Monitor Calibration Unit. The Calibration Unit is a most
important product which allows the customer to perform
NIST traceable calibration on continuous monitors. The
#50512 is designed to be used on the shop floor at the
workstation, virtually eliminating downtime, verifying that the
continuous monitor is operating within tolerances. Per
ANSI/ESD S20.20 Paragraph 6.2.2.2 Personnel Grounding
Guidance, “Personnel should check constant monitoring
devices (when used) to ensure that they are functional and
operating before ESDS products are handled. In addition,
constant monitoring devices should be functionally checked
periodically to ensure that they are operating as designed.”
2006 DESCO INDUSTRIES INC.
Employee Owned
相關PDF資料 |
PDF描述 |
|---|---|
| 19226 | MONITR CONTINUOUS MULTI-MNT 120V |
| 19228 | MONITOR CONT MULTI-MOUNT |
| 19230 | MONITOR DUAL WORKSTATION 120V |
| 19232 | MONITOR W/SPLIT REMOTE MOD 120V |
| 19240 | WRISTSTRAP TESTER 9V OPERATION |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 19-223/BHR6C-A30/2T | 制造商:Everlight Electronics Co 功能描述:19-223/BHR6C-A30/2T - Tape and Reel |
| 19-223/R6GHC-A01/2T | 制造商:Everlight 功能描述:LED |
| 19-223/S2GHC-C30/2T(WSN) | 制造商:Everlight Electronics Co 功能描述: |
| 19-223/S2T1D-C30/2T | 制造商:Everlight Electronics Co 功能描述: |
| 19-223/S2T1D-C30/2T(WSN) | 制造商:Everlight Electronics Co 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。