- 您現在的位置：買賣IC網 > PDF目錄382785 > μPD753018A (NEC Corp.) 4-Bit Single Chip Microcontroller(4位單片微控制器) PDF資料下載
參數資料
| 型號： | μPD753018A |
| 廠商： | NEC Corp. |
| 英文描述： | 4-Bit Single Chip Microcontroller(4位單片微控制器) |
| 中文描述： | 4位單片微控制器（4位單片微控制器） |
| 文件頁數： | 156/442頁 |
| 文件大?。?/td> | 1588K |
| 代理商： | ΜPD753018A |
CHAPTER 5 PERIPHERAL HARDWARE FUNCTION
134
(3) Timer/event counter operation
The timer/event counter operates as follows. To perform this operation, clear the gate control enable flag
(TGCE) of the timer/event counter control register (TC2) to 0.
Fig. 5-38 shows the configuration when the timer/event counter operates.
<1>
<2>
The count pulse (CP) is selected by the mode register (TMn) and is input to the count register (Tn).
The contents of Tn are compared with those of the modulo register (TMODn). When the contents of
these registers coincide, a coincidence signal is generated, and the interrupt request flag (IRQTn) is
set. At the same time, the timer out flip/flop (TOUT F/F) is inverted.
Fig. 5-39 shows the timing of the timer/event counter operation.
The timer/event counter operation is usually started in the following procedure:
<1>
<2>
Set the number of counts to TMODn.
Sets the operation mode, count pulse, and start command to TMn.
Caution Do not set a value other than 00H to the modulo register (TMODn).
To use the timer/event counter output pin (PTOn), set the P2n pin as follows:
<1>
<2>
<3>
<4>
Clear the output latch of P2n.
Set port 2 in the output mode.
Disconnect the internal pull-up resistor from port 2 (When outputting PTO2, disable PCL output).
Set the timer/event counter output enable flag (TOEn) to 1.
相關PDF資料 |
PDF描述 |
|---|---|
| μPD753036 | 4 Bit Single Chip Microcontrollers(4位單片微控制器) |
| μPD75P0076 | 4 Bit Single Chip Microcontrollers(4位單片微控制器) |
| μPD75P3018A | 4 Bit Single Chip Microcontrollers(4位單片微控制器) |
| μPD75P3036 | 4 Bit Single Chip Microcontrollers(4 位單片微控制器) |
| μPD75P70076 | 4 Bit Single Chip Microcontrollers(4位單片微控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PD75-333K | 功能描述:固定電感器 33uH 10% .15ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75-393K | 功能描述:固定電感器 39uH 10% .18ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75-473K | 功能描述:固定電感器 47uH 10% .21ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75-563K | 功能描述:固定電感器 56uH 10% .24ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| PD75-683K | 功能描述:固定電感器 68uH 10% .3ohm Choke SMT Power Ind RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
發布緊急采購，3分鐘左右您將得到回復。