- 您現在的位置：買賣IC網 > PDF目錄374895 > SPS-445-6-E (Sanyo Electric Co.,Ltd.) Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率56.8 kHz的接收前置放大器模塊) PDF資料下載
參數資料
| 型號： | SPS-445-6-E |
| 廠商： | Sanyo Electric Co.,Ltd. |
| 英文描述： | Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率56.8 kHz的接收前置放大器模塊) |
| 中文描述： | 接收機前置放大器的紅外遙控器（用于紅外遠程控制的載波頻率56.8千赫模塊的接收前置放大器模塊） |
| 文件頁數： | 3/5頁 |
| 文件大?。?/td> | 28K |
| 代理商： | SPS-445-6-E |
SPS-445 Series
No.6045 3/5
Measurement Condition
Block Diagram
Note 1. Vout : Active “Low” output
2. R..
to 51k
3. The power supply filter is not being attached.
GND
VCC
Vout
Fig.4 Block Diagram
RL
BPF
+
TRAP
ABLC
Amp.
Limiter
Detector
Waveform
Shaper
Controlling distance
L
DUT
Transmitter
DUT : Device Under Test
Fig.3 Measurement Condition
相關PDF資料 |
PDF描述 |
|---|---|
| SPS-445-E | Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率為40 kHz的接收前置放大器模塊) |
| SPS-446 | Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率為40 kHz的接收前置放大器模塊) |
| SPS-446-1 | Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率38 kHz的接收前置放大器模塊) |
| SPS-446-2 | Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率36.7 kHz的接收前置放大器模塊) |
| SPS-446-3 | Receiver Pre-amp Module for Infrared Remote Control(用于紅外遠程控制的載波頻率33.3 kHz的接收前置放大器模塊) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SPS-450 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Receiver Pre-amp Module for Infrared Remote Control |
| SPS-450-1-E | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Receiver Pre-amp Module for Infrared Remote Control |
| SPS-450-2-E | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Receiver Pre-amp Module for Infrared Remote Control |
| SPS-450-3-E | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Receiver Pre-amp Module for Infrared Remote Control |
| SPS-450-4-E | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:Receiver Pre-amp Module for Infrared Remote Control |
發布緊急采購，3分鐘左右您將得到回復。