- 您現在的位置：買賣IC網 > PDF目錄374749 > SDA9380-B21 (MICRONAS SEMICONDUCTOR HOLDING AG) EDDC Enhanced Deflection Controller and RGB Processor PDF資料下載
參數資料
| 型號： | SDA9380-B21 |
| 廠商： | MICRONAS SEMICONDUCTOR HOLDING AG |
| 元件分類： | 消費家電 |
| 英文描述： | EDDC Enhanced Deflection Controller and RGB Processor |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP64 |
| 封裝： | PLASTIC, MQFP-64 |
| 文件頁數： | 37/72頁 |
| 文件大?。?/td> | 366K |
| 代理商： | SDA9380-B21 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁當前第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
SDA 9380 - B21
Preliminary Data Sheet
System description
Micronas
5-29
2001-01-29
5.5.5 Explanation of some control items
Vertical aspect,
Vertical scroll:
Two special control items are implemented for the user to adjust the
vertical height (control item: Vertical aspect) and the vertical position
(Vertical scroll). These items may be stored for every display mode to
get an individual height and position if desired. Changing these para-
meters automatically influences the outputs VD+, VD-, E/W, HD in such
a way that absolutely no raster distortion happens. There is no need
for the user to re-adjust any geometry parameter.
The difference of the function of
Vertical size
and
Vertical aspect
is
the following: Varying Vertical size causes a linear stretching of the
saw-tooth to eliminate the tolerance of linear components (e.g. feed-
back resistor). But adjusting Vertical aspect takes into consideration
that more or less picture height needs very more or less S-correction
(no linear relation). Therefore
Vertical aspect
should be used for chang-
ing the aspect ratio (e.g. 16:9 source on 4:3 CRT) or if an individual
picture height is desired for the various PC graphic standards. Vertical
aspect = -128(minimum value) results in a vertical reduction to 37.5%.
The purpose of these control parameters is the alignment in the factory
and service to adapt the output signals VD+, VD- to the picture tube and
to eliminate tolerances of the hardware and deflection yoke. Only one
set of these parameters is required for all display modes.
Changing the vertical linearity and S-correction has no influence on the
Vertical S-correction:
E/W-geometry. That means, straight vertical lines remain straight. The
output signals E/W and HD are automatically changed so no re-adjust-
ment of the related control items is needed. This feature saves time for
adjustment of the so called ’smart’ mode (4:3 source on 16:9 CRT)
Guard band:
This control item is useful for optimizing self adaptation. Video signals
with different number of lines in consecutive fields (e.g. VCR search
mode) must not start the procedure of self adaptation. But switching
between different TV standards has to change the slope of the vertical
saw-tooth getting always the same amplitude (self adaptation). To avoid
problems with flicker free TV systems which have alternating number of
lines per field an average value of four consecutive fields is calculated. If
the deviation of these average values (e.g. PAL : 312.5 lines or 625 half
lines) is less or equals
Guard band
, no adaptation takes place. When it
exceeds
Guard band
, the vertical slope will be changed.
Vertical EHT comp.:
This item controls the influence of the beam current dependent input
signal IBEAM on the outputs VD+ and VD- according to the following
equation:
Vertical size,
Vertical shift:
Vertical linearity,
(if RIBM=0)
(if RIBM=1)
V
VDPP
: variation of VD+ and VD-peak-to-peak voltage
VVDPP
VIBEAM
=
1536
-------------------------------------------------------------------------------------
0.59
VVDPP
VIBEAM
=
512
-------------------------------------------------------------------------------------
0.59
相關PDF資料 |
PDF描述 |
|---|---|
| SDA9388X | Single-Chip Picture in Picture IC |
| SDA9400 | Scan Rate Converter using Embedded DRAM Technology Units |
| SDA9410-B13 | Display Processor and Scan Rate Converter using Embedded DRAM Technology Units |
| SDA9415-B13 | Display Processor and Scan Rate Converter |
| SDA9488X | Cost-effective Picture-In-Picture ICs |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SDA9388X | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Single-Chip Picture in Picture IC |
| SDA9400 | 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Scan Rate Converter using Embedded DRAM Technology Units |
| SDA9401 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Scan Rate Converter using Embedded DRAM Technology Units |
| SDA9410-B13 | 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Display Processor and Scan Rate Converter using Embedded DRAM Technology Units |
| SDA9415-B13 | 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Display Processor and Scan Rate Converter |
發布緊急采購，3分鐘左右您將得到回復。