參數資料
型號： SDA9380-B21
廠商： MICRONAS SEMICONDUCTOR HOLDING AG
元件分類： 消費家電
英文描述： EDDC Enhanced Deflection Controller and RGB Processor
中文描述： SPECIALTY CONSUMER CIRCUIT, PQFP64
封裝： PLASTIC, MQFP-64
文件頁數： 20/72頁
文件大?。?/td> 366K
代理商： SDA9380-B21
SDA 9380 - B21
Preliminary Data Sheet
System description
Micronas
5-12
2001-01-29
Once an increment has been obtained, either from the PI-filter or the I
2
C-bus, it can be used to
operate the Digital Timing Oscillator. The DTO generates a saw-tooth with a frequency that is pro-
portional to the increment. The saw-tooth is converted into a sinusoidal clock signal by means of sin
ROM’s and D/A converters and applied to an analog PLL which multiplies the frequency by 4 (for
detailed explanation see pinning and I
2
C-bus description) and minimizes residual jitter. In this man-
ner the required line locked clock is provided to operate the other functional parts of the circuit. If no
HSYNC is applied to pin 18 the system holds its momentary frequency for 2040 lines and following
resets the PLL to its nominal frequency. The status bit CON indicates the lock state of the PLL.
The system also provides a stable HS-pulse for internal use. The phase between this internal pulse
and the external HSYNC is adjustable via I
2
C bus bits HPHASE. It can be shifted over the range of
one TV line.
An external clock (CLKI) can be provided by pin selection (CLEXT = H) or I2C control (SCLIIC = H,
CLEXTIIC = H). This is recommended when using the SDA 9380 with a scan rate conversion sys-
tem. The clock frequency has to be 864 · f
HSYNC.
The external clock mode can not be used with
18.75, 33.75kHz, 35kHz and 38kHz line frequency. Therefore switching to external clock mode is
only possible when INCR = 6, but always allowed during operating without any danger for the H-out-
put stage.
The input signal at VSYNC is the vertical time reference. It has to pass a window avoiding too short
or long V-periods in the case of distorted or missing VSYNC pulses. The window allows a VSYNC
pulse only after a minimum number of lines from its predecessor and sets an artificial one after a
maximum number of lines. The window size is programmable by I
2
C-bus.
Values which influence shape and amplitude of the output signals are transmitted as reduced binary
values to the SDA 9380 via I2C bus. A CPU which is designed for speed reasons in a pipe line struc-
ture calculates in consideration of feedback signals (e.g. IBEAM) values which exactly represent the
output signals. These values control after D/A conversion the external deflection and raster correc-
tion circuits.
The CPU firmware is stored in an internal ROM.
相關PDF資料
PDF描述
SDA9388X Single-Chip Picture in Picture IC
SDA9400 Scan Rate Converter using Embedded DRAM Technology Units
SDA9410-B13 Display Processor and Scan Rate Converter using Embedded DRAM Technology Units
SDA9415-B13 Display Processor and Scan Rate Converter
SDA9488X Cost-effective Picture-In-Picture ICs
相關代理商/技術參數
參數描述
SDA9388X 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:Single-Chip Picture in Picture IC
SDA9400 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Scan Rate Converter using Embedded DRAM Technology Units
SDA9401 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Scan Rate Converter using Embedded DRAM Technology Units
SDA9410-B13 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Display Processor and Scan Rate Converter using Embedded DRAM Technology Units
SDA9415-B13 制造商:MICRONAS 制造商全稱:MICRONAS 功能描述:Display Processor and Scan Rate Converter
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*