- 您現在的位置：買賣IC網 > PDF目錄374747 > SDA5250M (SIEMENS A G) ICs for Consumer Electronics PDF資料下載
參數資料
| 型號： | SDA5250M |
| 廠商： | SIEMENS A G |
| 元件分類： | 圖文 |
| 英文描述： | ICs for Consumer Electronics |
| 中文描述： | TELETEXT AND VPS/PDC DECODER, PQFP80 |
| 文件頁數： | 78/143頁 |
| 文件大?。?/td> | 1050K |
| 代理商： | SDA5250M |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁當前第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁
SDA 525x
Semiconductor Group
78
1998-04-08
unintentionally entering the power-down mode. The following instruction sequence may
serve as an example:
ORL
PCON,#00000010
B
Set bit PDE, bit PDS must not be set.
ORL
PCON,#01000000
B
Set bit PDS, bit PDE must not be set.
The instruction that sets bit PDS is the last instruction executed before going into power-
down mode.
If idle mode and power-down mode are invoked simultaneously, the power-down mode
takes precedence.
The only exit from power-down mode is a hardware reset. The reset will redefine all
SFRs, but will not change the contents of internal RAM.
6.3.6
There are 26 I/O-pins configured as three 8-bit ports, one 4-bit-port (P2.0 – 2.3) and one
2-bit port (P4.0 – 4.1, P4.1 for ROM-less version only). Each pin can be individually and
independently programmed as input or output and each can be configured dynamically.
An instruction that uses a port's bit/byte as a source operand reads a value that is the
logical AND of the last value written to the bit/byte and the polarity being applied to the
pin/pins by an external device (this assumes that none of the processor's electrical
specifications are being violated). An instruction that reads a bit/byte, operates on the
content, and writes the result back to the bit/byte, reads the last value written to the
bit/byte instead of the logic level at the pin/pins. Pins comprising a single port can be
made a mixed collection of inputs and outputs by writing a “one” to each pin that is to be
an input. Each time an instruction uses a port as the destination, the operation must write
“ones” to those bits that correspond to the input pins. An input to a port pin needs not to
be synchronized to the oscillator.
All the port latches have “one” s written to them by the reset function. If a “zero” is
subsequently written to a port latch, it can be reconfigured as an input by writing a “one”
to it.
The instructions that perform a read of, operation on, and write to a port's bit/byte are
INC, DEC, CPL, JBC, SETB, CLR, MOV P.X, CJNE, DJNZ, ANL, ORL, and XRL. The
source read by these operations is the last value that was written to the port, without
regard to the levels being applied at the pins. This insures that bits written to a “one” (for
use as inputs) are not inadvertently cleared.
Port 0 has an open-drain output. Writing a “one” to the bit latch leaves the output
transistor off, so the pin floats.
In that condition it can be used as a high-impedance input. Port 0 is considered “true
bidirectional”, because when configured as an input it floats.
Ports 1, 3 and 4 have “quasi-bidirectional” output drivers which comprise an internal
pullup resistor of 10 k
to 40 k
. When configured as inputs they pull high and will
Ports and I/O-Pins
相關PDF資料 |
PDF描述 |
|---|---|
| SDA5251 | ICs for Consumer Electronics |
| SDA5251M | ICs for Consumer Electronics |
| SDA5254 | 8-BIT SINGLE CHIP MICROCONTROLLERS |
| SDA5254-2 | ICs for Consumer Electronics |
| SDA 5251 | TVTEXT 8-Bit Microcontroller(ROM-Versions )(TV視頻的8位微控制器（含ROM 型 ）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SDA5250M-2 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Consumer Electronics |
| SDA5251 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Consumer Electronics |
| SDA5251-2 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Consumer Electronics |
| SDA5251M | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Consumer Electronics |
| SDA5251M-2 | 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:ICs for Consumer Electronics |
發布緊急采購，3分鐘左右您將得到回復。