- 您現在的位置：買賣IC網 > PDF目錄296691 > NHI-1598ET/883 (NATIONAL HYBRID INC) 2 CHANNEL(S), MIL-STD-1553 CONTROLLER, CPGA69 PDF資料下載
參數資料
| 型號： | NHI-1598ET/883 |
| 廠商： | NATIONAL HYBRID INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 2 CHANNEL(S), MIL-STD-1553 CONTROLLER, CPGA69 |
| 封裝： | 1.100 X 1.100 INCH, CERAMIC, PLUG IN, PGA-69 |
| 文件頁數： | 57/89頁 |
| 文件大?。?/td> | 569K |
| 代理商： | NHI-1598ET/883 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁
-
59
8.1.3
BC MESSAGE TABLE
A message table is a block of consecutive memory which contains all the components of one
message. These components are:
BC Control word.
BC Command word.
Message gap word.
32 bit time tag( two words).
2nd Command word (RT- RT only).
Data words.
Status word.
2nd Status word( RT- RT only).
In the case of an RT- RT transfer, the second command and status words are also in the
message block as shown. The message block is designed to contain all the information
associated with the message. Parts of the message, the command word for example, are not
segregated into a separate ram area which would complicate reading or writing a message block
by the CPU. The unified message block approach used in the NHi- ET provides faster access to a
message block by the CPU and minimizes overhead.
8.1.4
BC CONTROL WORD
The BC control word is used by the CPU to define parameters in the message and it is used by
the Protocol chip to report information back to the CPU. The following parameters are loaded into
the BC control word by the CPU and used by the protocol chip for a message:
Status bit analysis.
Message bus - A or B.
Local retry actio in the event of an error. If there is no local retry, then the global retry action set in
configuration register 2 is used if an error occurs.
The following information about that message is loaded into the BC control word by the protocol
chip and used by the CPU:
Start of message flag.
No response.
Error.
Status bit set.
Retry attempted.
End of message flag.
8.1.5
BC COMMAND WORD
The command word is any of the 1553 valid commands. This word defines the type of data
transfer in the message BC to RT, RT to BC, RT to RT, or Mode code.
8.1.6
MESSAGE GAP WORD
The message gap word defines delay between the end of the current message and the start of
the next message in the list. The maximum intermessage gap is 4ms with a resolution 1us. The
minimum inter message gap is approximately 8us when the delay is set to 0. The following other
parameters are set in the message gap word:
Message stop on error.
Message stop on status set.
Interrupt on end of message.
NO- OP.
If the NO- OP is set in a message, the message is ignored except for its inter message delay.
相關PDF資料 |
PDF描述 |
|---|---|
| NJG1145UA2 | 90 MHz - 2150 MHz RF/MICROWAVE WIDE BAND LOW POWER AMPLIFIER |
| NJG1515AVB2 | RF/MICROWAVE TRANSFER SWITCH |
| NJG1667MD7 | 1000 MHz - 2500 MHz RF/MICROWAVE SGL POLE FIVE THROW SWITCH, 0.8 dB INSERTION LOSS |
| NJU6319DC | 6.25 MHz, OTHER CLOCK GENERATOR, UUC6 |
| NJU6338BE | 17.5 MHz, OTHER CLOCK GENERATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NHI21PKZ0 | 制造商:EATON MOELLER 功能描述:Contactor 制造商:EATON MOELLER 功能描述:CONTACTOR; Contact Configuration:3PST-2NO / SPST-NC; IP / NEMA Rating:IP20; No. of Poles:3 ;RoHS Compliant: Yes |
| NHI21-PKZ0 | 制造商:Moeller Electric Corporation 功能描述:Auxiliary Switch Nhi-Pkz0 |
| NHI21-PKZO | 制造商:EATON MOELLER 功能描述:CONTACT BLOCK 2NO+1NC |
| NHI350AM2 S LJ3S | 制造商:Intel 功能描述:Ethernet CTLR Single Chip 10Mbps/100Mbps/1000Mbps 3.3V 256-Pin BGA 制造商:Intel 功能描述:POWERVILLE, ETHERNET CONTROLLER I350-AM2 - Trays |
| NHI350AM2 S LJ3S | 制造商:Intel 功能描述:Ethernet ICs Controller IEEE 10/ 100/1000 Mbps BGA256 |
發布緊急采購，3分鐘左右您將得到回復。