- 您現在的位置：買賣IC網 > PDF目錄359234 > MT9046AN (ZARLINK SEMICONDUCTOR INC) T1/E1 System Synchronizer with Holdover PDF資料下載
參數資料
| 型號： | MT9046AN |
| 廠商： | ZARLINK SEMICONDUCTOR INC |
| 元件分類： | 通信及網絡 |
| 英文描述： | T1/E1 System Synchronizer with Holdover |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PDSO48 |
| 封裝： | 0.300 INCH, MO-118AA, SSOP-48 |
| 文件頁數： | 19/34頁 |
| 文件大?。?/td> | 508K |
| 代理商： | MT9046AN |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁當前第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
MT9046
Data Sheet
19
Zarlink Semiconductor Inc.
Crystal Oscillator
- Alternatively, a Crystal Oscillator may be used. A complete oscillator circuit made up of a
crystal, resistor and capacitors is shown in Figure 9.
Figure 9 - Crystal Oscillator Circuit
The accuracy of a crystal oscillator depends on the crystal tolerance as well as the load capacitance tolerance.
Typically, for a 20 MHz crystal specified with a 32 pF load capacitance, each 1 pF change in load capacitance
contributes approximately 9 ppm to the frequency deviation. Consequently, capacitor tolerances, and stray
capacitances have a major effect on the accuracy of the oscillator frequency.
The trimmer capacitor shown in Figure 9 may be used to compensate for capacitive effects. If accuracy is not a
concern, then the trimmer may be removed, the 39 pF capacitor may be increased to 56 pF, and a wider tolerance
crystal may be substituted.
The crystal should be a fundamental mode type - not an overtone. The fundamental mode crystal permits a simpler
oscillator circuit with no additional filter components and is less likely to generate spurious responses. The crystal
specification is as follows.
Frequency:
Tolerance:
Oscillation Mode:
Resonance Mode:
Load Capacitance:
Maximum Series Resistance:
Approximate Drive Level:
e.g., R1B23B32-20.0 MHz
(20 ppm absolute,
±
6 ppm 0C to 50C, 32 pF, 25
)
20 MHz
As required
Fundamental
Parallel
32 pF
35
1 mW
TIE Correction (using PCCi)
When Primary Holdover Mode is entered for short time periods, TIE correction should not be enabled. This will
prevent unwanted accumulated phase change between the input and output.
For instance, 10 Normal to Holdover to Normal mode change sequences occur, and in each case Holdover was
entered for 2s. Each mode change sequence could account for a phase change as large as 350 ns. Thus, the
accumulated phase change could be as large as 3.5 us, and, the overall MTIE could be as large as 3.5 us.
OSCo
56 pF
1 M
39 pF
3-50 pF
20 MHz
MT9046
OSCi
100
1 uH
1 uH inductor: may improve stability and is optional
相關PDF資料 |
PDF描述 |
|---|---|
| MT90503 | 2048VC AAL1 SAR |
| MT90503AG | CLIP, STRAIN RELIEF, 50WAY; For use with:820 Series Tripolarized Wiremount Sockets; Ways, No. of:50; Material:Metal; Connector type:Strain Relief RoHS Compliant: Yes |
| MT90520 | 8-Port Primary Rate Circuit Emulation AAL1 SAR |
| MT90520AG | 8-Port Primary Rate Circuit Emulation AAL1 SAR |
| MT9072 | Ultraframer DS3/E3/DS2/E2/DS1/E1/DS0 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MT9046AN1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1 /T1 3.3V 48SSOP - Rail/Tube 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC SYNCHRONIZER T1/E1 48SSOP 制造商:Microsemi Corporation 功能描述:IC SYNCHRONIZER T1/E1 48SSOP |
| MT9046ANR1 | 制造商:Microsemi Corporation 功能描述:FRAMER E1 /T1 3.3V 48SSOP - Tape and Reel 制造商:MICROSEMI CONSUMER MEDICAL PRODUCT GROUP 功能描述:IC SYNCHRONIZER T1/E1 48SSOP 制造商:Microsemi Corporation 功能描述:IC SYNCHRONIZER T1/E1 48SSOP |
| MT9048 | 制造商:DBLECTRO 制造商全稱:DB Lectro Inc 功能描述:Standard Type |
| MT90489 | 制造商: 功能描述: 制造商:undefined 功能描述: |
| MT904CP | 制造商:MITEL 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。