- 您現在的位置：買賣IC網 > PDF目錄384710 > MAX8860 (Maxim Integrated Products, Inc.) Low-Dropout, 300mA Linear Regulator in レMAX PDF資料下載
參數資料
| 型號： | MAX8860 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Low-Dropout, 300mA Linear Regulator in レMAX |
| 中文描述： | 低壓差、300mA線性穩壓器，µMAX封裝 |
| 文件頁數： | 8/8頁 |
| 文件大?。?/td> | 137K |
| 代理商： | MAX8860 |
M
Low-Dropout, 300mA
Linear Regulator in μMAX
Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are
implied. Maxim reserves the right to change the circuitry and specifications without notice at any time.
8
_____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
1999 Maxim Integrated Products
Printed USA
is a registered trademark of Maxim Integrated Products.
V
IN
> +5.5V Minimum Load
Current Requirements
When operating the MAX8860 with an input voltage
above +5.5V, a minimum load current of 20μA is
required to maintain regulation in preset voltage mode.
When setting the output with external resistors, ensure
that the minimum current through the external feedback
resistors and load is at least 30μA. This applies only
when the input voltage exceeds +5.5V. For input volt-
ages less than +5.5V, the MAX8860 maintains regula-
tion and stability without external loading.
Applications Information
Capacitor Selection and
Regulator Stability
Typically, use a 2.2μF capacitor on the input and a
2.2μF capacitor on the output of the MAX8860.
Capacitor type is not critical, as long as it has an ESR
less than 0.5
. Larger capacitor values and lower ESR
provide better supply-noise rejection and transient
response. Use higher-value capacitors (10μF) if large,
fast input or load transients are anticipated or if the
device is located several inches from the power source.
For stable operation over the full temperature range,
with load currents up to 300mA, a minimum output-
capacitor value of 2.2μF is recommended. There is no
upper limit to capacitor size. The circuit used to gener-
ate the typical operating characteristics data used
2.2μF, X7R, 16V (1206) ceramic capacitors. These
capacitors typically have an ESR of 50m
.
Power-Supply Rejection and Operation
from Sources Other than Batteries
The MAX8860 is designed to deliver low dropout volt-
age and low quiescent current in battery-powered sys-
tems. Power-supply rejection is 67dB at low frequencies
and rolls off above 100kHz. At high frequencies, the out-
put capacitor is the major contributor to the rejection of
power-supply noise (see the Power-Supply Rejection
Ratio vs. Frequency graph in the
Typical Operating
Characteristics
).
When operating from sources other than batteries,
improve supply-noise rejection and transient response
by increasing the values of the input and output capaci-
tors, and by using passive filtering techniques (see the
supply and load-transient responses in the
Typical
Operating Characteristics
).
Load-Transient Considerations
The MAX8860 load-transient response graph (see
Typical Operating Characteristics
) shows the output
response due to changing load current. Reduce over-
shoot by increasing the output capacitor’s value and
decreasing its ESR.
Input-Output (Dropout) Voltage
A regulator’s minimum input-output voltage differential
(or dropout voltage) determines the lowest usable supply
voltage. In battery-powered systems, this determines the
useful end-of-life battery voltage. Because the MAX8860
uses a P-channel MOSFET pass transistor, its dropout
voltage is a function of R
DS(ON)
(typically 0.5
) multi-
plied by the load current (see
Electrical Characteristics
).
Chip Information
TRANSISTOR COUNT: 148
相關PDF資料 |
PDF描述 |
|---|---|
| MAX8863TEUK-T | Low-Dropout, 120mA Linear Regulators |
| MAX8864TEUK-T | Low-Dropout, 120mA Linear Regulators |
| MAX8863REUK-T | Low-Dropout, 120mA Linear Regulators |
| MAX8864REUK-T | Low-Dropout, 120mA Linear Regulators |
| MAX8863TEUK | PLASTIC ENCAPSULATED DEVICES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX8860ESA33 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX8860ESA33.TG002 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX8860ESA33-T | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX8860EUA18 | 功能描述:低壓差穩壓器 - LDO 300mA Linear Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| MAX8860EUA18+ | 功能描述:低壓差穩壓器 - LDO 300mA Linear Regulator RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。