- 您現在的位置：買賣IC網 > PDF目錄359063 > M41T81SMY6F (意法半導體) Serial Access Real-Time Clock with Alarms PDF資料下載
參數資料
| 型號： | M41T81SMY6F |
| 廠商： | 意法半導體 |
| 英文描述： | Serial Access Real-Time Clock with Alarms |
| 中文描述： | 串行訪問實時時鐘與鬧鐘 |
| 文件頁數： | 15/29頁 |
| 文件大小： | 438K |
| 代理商： | M41T81SMY6F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
15/29
M41T81S
Setting Alarm Clock Registers
Address locations 0Ah-0Eh contain the alarm set-
tings. The alarm can be configured to go off at a
prescribed time on a specific month, date, hour,
minute, or second or repeat every year, month,
day, hour, minute, or second. It can also be pro-
grammed to go off while the M41T81S is in the
battery back-up mode to serve as a system wake-
up call.
Bits RPT5-RPT1 put the alarm in the repeat mode
of operation.
Table 3., page 16
shows the possible
configurations. Codes not listed in the table default
to the once per second mode to quickly alert the
user of an incorrect alarm setting.
When the clock information matches the alarm
clock settings based on the match criteria defined
by RPT5-RPT1, the AF (Alarm Flag) is set. If AFE
(Alarm Flag Enable) is also set (and SQWE is '0.'),
the alarm condition activates the IRQ/FT/OUT/
SQW pin.
Note:
If the address pointer is allowed to incre-
ment to the Flags Register address, an alarm con-
dition will not cause the Interrupt/Flag to occur until
the address pointer is moved to a different ad-
dress. It should also be noted that if the last ad-
dress written is the “Alarm Seconds,” the address
pointer will increment to the Flag address, causing
this situation to occur.
The IRQ/FT/OUT/SQW output is cleared by a
READ to the Flags Register as shown in Figure
14
. A subsequent READ of the Flags Register is
necessary to see that the value of the Alarm Flag
has been reset to '0.'
The IRQ/FT/OUT/SQW pin can also be activated
in the battery back-up mode. The IRQ/FT/OUT/
SQW will go low if an alarm occurs and both ABE
(Alarm in Battery Back-up Mode Enable) and AFE
are set. Figure
15
illustrates the back-up mode
alarm timing.
Figure 14. Alarm Interrupt Reset Waveform
Figure 15. Back-up Mode Alarm Waveform
IRQ/FT/OUT/SQW
ACTIVE FLAG
0Fh
0Eh
10h
HIGH-Z
AI04617
V
CC
IRQ/FT/OUT/SQW
ABE and AFE Bits
AF Bit in Flags
Register
HIGH-Z
V
SO
V
PFD
trec
AI09164b
相關PDF資料 |
PDF描述 |
|---|---|
| M440T1MV-15ZA9 | 3.3V, 32 Mbit (1024 Kbit x 32) TIMEKEEPER SRAM |
| M440T1MV | 3.3V, 32 Mbit (1024 Kbit x 32) TIMEKEEPER SRAM |
| M45PE20-VMN6 | 4 Mbit Uniform Sector, Serial Flash Memory |
| M45PE20 | 4 Mbit Uniform Sector, Serial Flash Memory |
| M45PE20-VMP6TP | 4 Mbit Uniform Sector, Serial Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| M41T81SMY6FT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial Access Real-Time Clock with Alarms |
| M41T81SMY6T | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial Access Real-Time Clock with Alarms |
| M41T82 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial I2C bus RTC with battery switchover |
| M41T82_08 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial I2C bus RTC with battery switchover |
| M41T82_10 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Serial I2C bus RTC with battery switchover |
發布緊急采購，3分鐘左右您將得到回復。