- 您現在的位置：買賣IC網 > PDF目錄11576 > KSZ8873MLL AM TR (Micrel Inc)IC ETHERNET SWITCH 3PORT 64LQFP PDF資料下載
參數資料
| 型號： | KSZ8873MLL AM TR |
| 廠商： | Micrel Inc |
| 文件頁數： | 41/115頁 |
| 文件大小： | 0K |
| 描述： | IC ETHERNET SWITCH 3PORT 64LQFP |
| 產品培訓模塊： | KSZ8873 Ethernet Switches |
| 標準包裝： | 1,000 |
| 控制器類型： | 以太網開關控制器 |
| 接口： | MII |
| 電源電壓： | 1.8V，2.5V，3.3V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-LQFP |
| 供應商設備封裝： | 64-PQFP（10x10） |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁
Micrel, Inc.
KSZ8873MLL/FLL/RLL
September 20, 2013
31
Revision 1.6
To avoid jabber and excessive deference (as defined in the 802.3 standard), after a certain time, the
KSZ8873MLL/FLL/RLL discontinues the carrier sense and then raises it again quickly. This short silent time (no carrier
sense) prevents other stations from sending out packets thus keeping other stations in a carrier sense deferred state. If
the port has packets to send during a backpressure situation, the carrier sense type backpressure is interrupted and those
packets are transmitted instead. If there are no additional packets to send, carrier sense type backpressure is reactivated
again until switch resources free up. If a collision occurs, the binary exponential back-off algorithm is skipped and carrier
sense is generated immediately, thus reducing the chance of further collisions and carrier sense is maintained to prevent
packet reception.
To ensure no packet loss in 10 BASE-T or 100 BASE-TX half duplex modes, the user must enable the following:
1.
Aggressive back-off (Register 3 (0x03), bit [0])
2.
No excessive collision drop (Register 4 (0x04), bit [3])
Note: These bits are not set as defaults, as this is not the IEEE standard.
Broadcast Storm Protection
The KSZ8873MLL/FLL/RLL has an intelligent option to protect the switch system from receiving too many broadcast
packets. As the broadcast packets are forwarded to all ports except the source port, an excessive number of switch
resources (bandwidth and available space in transmit queues) may be utilized. The KSZ8873MLL/FLL/RLL has the option
to include “multicast packets” for storm control. The broadcast storm rate parameters are programmed globally, and can
be enabled or disabled on a per port basis. The rate is based on a 67ms interval for 100BT and a 500ms interval for
10BT. At the beginning of each interval, the counter is cleared to zero, and the rate limit mechanism starts to count the
number of bytes during the interval. The rate definition is described in Register 6 (0x06) and 7 (0x07). The default setting
is 0x63 (99 decimal). This is equal to a rate of 1%, calculated as follows:
148,800 frames/sec * 67ms/interval * 1% = 99 frames/interval (approx.) = 0x63
Note: 148,800 frames/sec is based on 64-byte block of packets in 100BASE-TX with 12 bytes of IPG and 8 bytes of
preamble between two packets.
Port Individual MAC Address and Source Port Filtering
The KSZ8873MLL/FLL/RLL provide individual MAC address for port 1 and port 2 respectively. They can be set at Register
142-147 and 148-153. With this feature, the CPU connected to the port 3 can receive the packets from two internet
subnets which has their own MAC address.
The packet will be filtered if its source address matches the MAC address of port 1 or port 2 when the Register 21 and 37
bit 6 is set to 1 respectively. For example, the packet will be dropped after it completes the loop of a ring network.
MII Interface Operation
The media independent interface (MII) is specified in Clause 22 of the IEEE 802.3u Standard. It provides a common
interface between physical layer and MAC layer devices. The MII provided by the KSZ8873MLL/FLL is connected to the
device’s third MAC. The interface contains two distinct groups of signals: one for transmission and the other for reception.
Table 4 describes the signals used by the MII bus.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16C54CT-04I/SO | IC MCU OTP 512X12 18SOIC |
| PIC12CE519T-04I/SN | IC MCU OTP 1KX12 W/EE 8SOIC |
| V300A8C400BG | CONVERTER MOD DC/DC 8V 400W |
| LTC1955IUH#PBF | IC SMART CARD INTERFACE DL 32QFN |
| V300A8C400BF3 | CONVERTER MOD DC/DC 8V 400W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8873MLL-EVAL | 功能描述:以太網開發工具 3-Port Fast Ethernet Switch with 1x MII Interface - Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ8873MLLI | 功能描述:以太網 IC 3-Port Fast Ethernet Switch with 1x RMII Interface (Industrial Grade, Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8873MLLJ | 功能描述:以太網 IC 3-Port Fast Ethernet Switch with 1x RMII Interface (Extended Temp) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8873MML | 功能描述:以太網 IC 3-Port Fast Ethernet Switch with 2x MII Interface, Lead Free RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8873MML-EVAL | 功能描述:以太網開發工具 3-Port Fast Ethernet Switch with 2x MII Interface - Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
發布緊急采購，3分鐘左右您將得到回復。