參數資料
型號: S1C6N3B0D0A0100
元件分類: 微控制器/微處理器
英文描述: MICROCONTROLLER, UUC54
封裝: DIE-54
文件頁數: 48/79頁
文件大?。?/td> 606K
代理商: S1C6N3B0D0A0100
44
EPSON
S1C6N3B0 TECHNICAL MANUAL
CHAPTER 4: PERIPHERAL CIARCUITS AND OPERATION (Stopwatch Timer)
4.8.5 Programming notes
(1) Note that the frequencies and times differ from the description in this section when the oscillation
frequency is not 32.768 kHz.
(2) If the timer data is read while running, a correct read may be impossible because of the carry from the
low-order bit (SWL) to the high-order bit (SWH). This occurs if reading has extended over the SWL
and SWH bits when the carry occurs. To prevent this, read after stopping, and then continue running.
Also, the stopped duration must be within 976 sec (256 Hz, 1/4 cycle).
(3) Reading of interrupt factor flags are available at EI, but be careful in the following cases.
If the interrupt mask register value corresponding to the interrupt factor flag to be read is set to "1", an
interrupt request will be generated by the interrupt factor flag set timing, or an interrupt request will
not be generated. Be very careful when interrupt factor flags are in the same address.
相關PDF資料
PDF描述
S1C6P366D0A0100 4-BIT, FLASH, 4.1 MHz, MICROCONTROLLER, UUC102
S1C6P466D0A0A00 MICROCONTROLLER, UUC140
S1C6S2L7D 4-BIT, MROM, 0.032 MHz, MICROCONTROLLER, UUC58
S1C6S2A7F 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, PQFP60
S1C6S2B7F 4-BIT, MROM, 0.08 MHz, MICROCONTROLLER, PQFP60
相關代理商/技術參數
參數描述
S1C-6-S 制造商:GRIPCO 功能描述:
S1C7309X 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:B/W CCD PROCESSOR
S1C7309X01 制造商:SAMSUNG 制造商全稱:Samsung semiconductor 功能描述:B/W CCD PROCESSOR
S1C88349 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer
S1C88649 制造商:EPSON 制造商全稱:EPSON 功能描述:8-bit Single Chip Microcomputer